Volume 5, Issue 2 (3-2015)
IJOCE 2015, 5(2): 227-240 |
Back to browse issues page
Download citation:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
BibTeX | RIS | EndNote | Medlars | ProCite | Reference Manager | RefWorks
Send citation to:
Dehghani H, Fadaee M J. OPTIMUM RESISTANCE FACTOR FOR REINFORCED CONCRETE BEAMS RETROFITTED WITH U-WRAP FRP. IJOCE 2015; 5 (2) :227-240
URL: http://ijoce.iust.ac.ir/article-1-212-en.html
URL: http://ijoce.iust.ac.ir/article-1-212-en.html
Abstract: (20539 Views)
The use of fiber reinforced polymer (FRP) U-wrap to rehabilitate concrete beams has increased in popularity over the past few years. As such, many design codes and guidelines have been developed to enable designers to use of FRP for retrofitting reinforced concrete beams. FIB is the only guideline for design which presents a formula for torsional capacity of concrete beams strengthened with FRP. The Rackwitz-Fiessler method was applied to make a reliability assessment on the torsional capacity design of concrete beams retrofitted with U-wrap FRP laminate by this guideline. In this paper, the average of reliability index obtained is 2.92, reflecting reliability of the design procedures. This value is somehow low in comparison to target reliability level of 3.5 used in the guideline calibration and so, optimum resistance factor may be needed in future guideline revisions. From the study on the relation between average reliability index and optimum resistance factor, a value of 0.723 for the optimum resistance factor is suggested.
Keywords: fiber reinforced polymer, reliability analysis, optimum resistance factor, torsion retrofitting, concrete beams.
Type of Study: Research |
Subject:
Optimal design
Received: 2015/04/1 | Accepted: 2015/04/1 | Published: 2015/04/1
Received: 2015/04/1 | Accepted: 2015/04/1 | Published: 2015/04/1
| Rights and permissions | |
 | This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License. |
